The screw will not come out. Apple never developed the hardware for it. Hard disk screw Gently pull up on the small metal tab located on the left side of the hard disk to disengage the hard disk from the logic board. ® Power button You should hear a tone when you turn on the computer. This revision will be supported when it is rolled into the next official software update. Then, grab the charger board as shown, and gently wiggle it out of its connector.
Place your hands on the right hand and left hand side of the monitor, and lift the display out of the casing. If you are new to America Online, click Continue in the dialog box that appears. Screws Press down on the bottom portion of the heat sink to secure it into place. If you see a message telling you to reinsert the module, the module is still in Important use. Make sure your equipment is connected properly. Hot Issues PowerBook 3400: Modem Driver Update - 2 PowerBook 3400: Modem Driver Update Issue: Customers may report one of the following problems with their PowerBook 3400 modem: 1 The modem will not reset following a disconnect. The Modem Driver update is posted at the Apple Software Updates site.
Complete technical specifications are below. In the Shut Down dialog box, click Shut Down. This chapter is not intended to replace other parts of this manual; it merely provides a pointer to pertinent information in those chapters. For answers to your PowerBook G3 questions, please read the. Press the Open button on the outside of the module to open its tray. Then try pressing the Power button ® again. Remove the two screws that secure the internal heat sink using a Phillips or Torx T-8 screwdriver and then lift it up by pulling on the small metal tab.
If you need to order any of these parts, they are available from www. To see if a modem is installed, open the modem panel on the left side of the computer. The telephone line must be an analog line—the type used in residences. To insert an expansion bay module, follow these steps: If the expansion bay that you want to use already has a module in place, remove it as described in the previous section. Save your work and then shut down the computer, put it to sleep, or plug in the power adapter. The design of the rear ports is as in the picture below.
Insert the internal heat sink and replace the two screws to secure it in place. Hold down the sound board and gently pull up on the cable. The PowerBook G3 Pismo was the last of the G3 line. It will come out easily. If a disc icon appears on your screen, do one of the following: m Select the disc icon on your screen and drag the icon to the Trash. The keyboard was also improved and now featured translucent bronze-tinted plastics. The Info article provides installation instructions.
This can sometimes take a lot of force. Loosen as much as you can. PowerBooks tend to look very similar, and it's important to know which machine you have before ordering any replacement parts. Using a flat head tool, pry up the flat plastic covering on the bottom of the display on either side of the cables. You can place a chip in each one for a gigabyte of memory.
Attempting to repair the computer yourself may void the limited warranty. You may feel some resistance. The customer-reportedsymptoms related to this issue include no display image or backlight while the computer is running. Simply pull the expansion bay lever towards you to eject the device. To remove the processor, put the flathead screwdriver on the right hand side of the processor as shown.
. This chapter alerts you to important issues and provides links to other areas in the manual where more complete information can be found. Then pull the device out so the bays are completely empty. If you are using a printer from a manufacturer other than Apple, you may need to install a printer driver. Please be mindful of asterisks, as these indicate particularly important details are provided on the applicable specs page.