This model is equipped with the electrically adjustable windshield. Fuel Tank Drain Hose 3. The dif- ference between the highest and lowest gauge readings is the amount of free play. Illustrations and photographs in this publication are intended for reference use only and may not depict actual model component parts. To the fitting of the throttle body 4.
This manual contains a lot of technical information, pictures, photos and schematics, step-by-step instructions that will be understandable to both beginners and professionals. Alternator Connectors 1-pin × 3 7. Take out only the caliper mounting bolts for caliper removal. Inlet Air Temperature Sensor Lead 2. Electric Windshield Relay Down 8.
Run the oxygen sensor leads, and close the clamp. Overall Width 1 000 mm 39. Always pull the chain taut while turn- ing the crankshaft. Run the speed sensor lead to the outside of the fuel tank drain hose, alternator lead, and fuel tank breather hose and to the inside of the air cleaner drain hose, idle adjuster screw, and clutch hose. Ignition Fuse 10 A 4.
Starter Motor Brush Length Standard: 10 mm 0. If the low beam headlight does not go on, inspect or re- place the following item. Pad Install the pad from the outside. Then tighten them according to the specified se- quence to prevent case warpage or deformation which can lead to malfunction. Main Fuse 30 A 7.
Main Fuse 30 A 4. Power Supply to Front Wheel Rotation Sensor 13. Special tools, gauges, and Indicates a procedural step or work to be testers that are necessary when servicing done. If the needle does not move, go to the Check 1 and in- spect the following items. Run the fuel tank drain hose to the backside of the clamp. Engine Oil and Oil Filter.
To the fitting of the throttle body 3. Torque - Tire Pressure Measurement sensor: 4. Crankshaft 3 Main Journal Width 27. Ring Gear Shim s 2. .
Run the clutch hose to the inside of the subframe. If the frame is bent, dented, cracked, or warped, replace it. If the seal is torn or is leaking, replace the bearing. Battery 12 V 14 Ah 8. Final Gear Case Oil: Amount: about 160 mL 5.
Such a shock to their parts can damage them. Front Wheel Rotation Sensor 5. Run the air cleaner drain hose through the front of the clamp. Rear Brake Light Switch Lead 4. Inlet air pressure sensor trouble Inspect see chapter 3. L: Apply a non-permanent locking agent.