Note: If the thermostat shows a Low Battery Warning,the backlight will not operate. Repeat steps 1-9 to schedule the Next time and set the temperature for your sleep per Summary of the content on the page No. Wires should be insertedbehind the black terminal shields. Indicates you are in scheduling options. Auto cut off — automatically turns the systemoff if the temperature rises above 95o F 35oC or drops below 40o F 4o C.
Tap the plastic anchors into the holes untilthey are flush with the wall. Sets the Home Today feature for when you are home during a regularly schedu Summary of the content on the page No. . We recommend using these pre-programmed settings for a few days before altering them as they offer maximum energy saving benefits. Refer to the Default Programs Chart for detailedinformation about the pre-programmed settings.
Be sure to wait up to 4 minutes for system protection if your system was just on. . Other Thoughts: When I first got it programmed and set it to run, it was putting out heat instead of cool air. Altering these schedules has a direct impact on the energy savings indicator. This can include days you will be away for vacation, or a few hours away from your home, while running errands for example. Programming seemed fairly straight-forward, except I could not figure out what to do for a time period that you did not want programmed.
My last Hunter lasted 12 years and is still working - I just wanted more features! Allows access to the advanced features of the thermostat. The Energy Guide gives you instant savings feedback as you change the settings and the Save Away one-touch override - for times you are away - gives you even more opportunities to save. Conventional systems typically use a compressor outside for cooling and a seperate heating system inside, where as a heat pumps use the compressor outside for both heat and cool. Insert the bare end of each wire all the way into the appropriate hole in the terminal block that matches the wire label then lower the lever. Posted on May 28, 2011 www. Then you will have the connections you need.
Start by pressing the first day you want to program on the day select screen. Other Thoughts: It is a good quality thermostat with excellent features however for the price, I would rather go for a Honeywell touchscreen since it is easier to program and the screen does not have any contrast issues. Use the and buttons to change the temperature and press. The switch has no effect when the system is set tocooling mode. Manual operation instructions are on pages 28-31.
The connectors on the white rodgers should have markings. Low battery warning — indicates two stages ofbattery power shortage. If you have seven wires now, then you more than likely have a heat pump system and you have to get a thermostat that is compatible with this type of system. Resume Temporary Schedule Change setting temporary temperature hold Home Schedule Menu Done ©2010 Hunter Fan Company Scheduling Cool to Done. Press the Up or Down buttons to adjust thetemperature setting as desired. The blue wire should go to B, or C.
Use the or button to select your current day, Next Next then to move to month, and then year, until each is set. You must label all wires properly because wire color may not indicate the function of the wire. Loosen, but do not remove, the terminalscrews. As for programming, I find the Honeywell's easier to program than this Hunter. There may be as much as a 4-minute delay beforethe system turns on or off to protect the compressor. Match and connect the wiresfrom the wall to the terminals asshown.
Using a Phillips Screwdriver, Partially install 1 screw into the top hole of the thermostat. Connect 1 wire to the Rh terminal and the other to W. Nothing will display when set Summary of the content on the page No. Low Battery: This will appear in the message window when your batteries are starting to run low on power and should be changed to avoid system interruptions, Figure 1. To create custom programs, see pages 34-37.